How to reconstitute sermorelin
Step-by-step instructions cover mixing a Sermorelin vial with bacteriostatic water, along with the units in each dose after mixing.
- sizes of vials sold
- 5, 10 mg
- Water makes 5 mg into 2.5 mg/mL.
- 2 mL
- bac water after it's opened
- 28 days
How to mix Sermorelin in steps
- Clean both rubber stoppers, the peptide vial and bacteriostatic water with an alcohol swab. Wash your hands before you start.
- Load the syringe with the amount of water you chose. With 2 mL in a 5 mg vial, you get 2.5 mg per mL.
- At a slight angle, push the needle through the stopper; let the water flow slowly along the vial's inside wall.
- Roll the vial gently in your hands until no powder is left. Don't shake it.
- Mark the vial with the mix date, then store it as your product or prescription directs.
- Find your dose in units, then draw to that line.
Reconstitution chart for Sermorelin
| Vial | Water added | Strength | Units for a sample dose |
|---|---|---|---|
| 5 mg | 1 mL | 5 mg/mL | 5 units for 250 mcg |
| 5 mg | 2 mL | 2.5 mg/mL | 10 units for 250 mcg |
| 5 mg | 3 mL | 1.667 mg/mL | 15 units for 250 mcg |
| 10 mg | 1 mL | 10 mg/mL | 2.5 units for 250 mcg |
| 10 mg | 2 mL | 5 mg/mL | 5 units for 250 mcg |
| 10 mg | 3 mL | 3.333 mg/mL | 7.5 units for 250 mcg |
Units for the Sermorelin dose you're using
Details on the label
It isn't FDA-approved for any use in people; it's sold as a research chemical. Since no FDA label exists, there are no official mixing instructions; follow the instructions that came with the product.
Questions people often ask
How much bacteriostatic water is used for 5 mg of Sermorelin?
There isn't one correct amount. With 2 mL, you get 2.5 mg per mL; adding more water weakens each unit and makes small doses easier to draw.
Can sterile water be used to mix Sermorelin?
Because sterile water has no preservative and is for one use, you usually mix a vial you draw from over days with bacteriostatic water. Read bacteriostatic water vs sterile water.